This guide describes the steps required to configure a
Cisco 350 series Access Point.STEP 1 - Set
the IP Address and SSID of the Access Point
Open your Internet Browser and navigate to the IP
Address of the Cisco 350 Series AP 12.00T (refer to Cisco 350 Series AP
12.00T documentation for default IP Address).
Once you’ve reached the Cisco 350 Series AP 12.00T
Home page, click the Setup Link (third link from the right at top of
page).
Click the Identification link for AP Radio, which is
located under Network Ports at the bottom left of the Setup screen.
If needed you can change the Default IP Address from
this page. Also, you will need to setup a Service Set ID (SSID) for the
Access Point to use. After updating these values, click the OK button to
save you’re your changes.
Step 2 – Setup WEP Keys on the Access Point
Click the Hardware link for AP Radio, which is
located under Network Ports at the bottom left of the Setup screen (SEE
Step 1 for instructions on navigating to the Setup page).
If you have not already set the Service Set ID (SSID)
on the Identification page then you can set it from this Page. You may
also want to set the ‘Allow “Broadcast” SSID to Associate?’ option to no
for security reasons. Next, Click the Radio Date Encryption (WEP) link at
the bottom of this page.
From the AP Radio Data Encryption page you can set
WEP Keys values for your access point to use. Once you are finished
settings up the various WEP Key values click the OK button to save you’re
your changes.
|
